MPS Terminated Harness MaxxECU Sport
The MPS Terminated MaxxECU Sport EFI Harness
simplifies the installation of your MaxxECU Sport EFI on Suzuki
Hayabusa, Suzuki GSXR1000, Suzuki GS, Kawasaki ZX14, Kawasaki ZX10, and
Kawasaki KZ motorcycles. The harness was designed for the ECU to be
mounted in the front under the dash or in the rear sub
frame.
The harness is covered and terminates all the critical (needed to run)
components of the EFI system. Using this terminated harness will
greatly reduce the chance of problems when installing your MaxxECU EFI
system. If you are not comfortable or do not have the tools to crimp
all the styles of connectors this harness is for you.
This harness will plug into your crank sensor (customer specified
type – GSXR1000, ZX14, ZX10, MPS Hall Effect pick up for GS & KZ),
cam sensor (customer specified type – Gen 1 & Gen 2 Hayabusa,
GSXR1000), injectors (customer specified type – Gen 1 Hayabusa, Gen 2
Hayabusa, GSXR1000, Bosch EV1, and Bosch EV14 ), Throttle Position
Sensor (customer specified type – Gen 1 Hayabusa, Gen 2 Hayabusa, and
ZX14), Bosch style igniter (MPS p/n 1-0783), coils (stock or aftermarket
stick type), air temperature sensor (customer specified type – Suzuki
or MPS), coolant temperature sensor (customer specified type – Suzuki or
MPS), Bosch Style O2 Sensor, fuel pressure (MPS p/n 1-0597), and oil
pressure (MPS p/n 1-0598). A MAP sensor is not required as the MaxxECU
has a built in MAP sensor. A MAP sensor is not used for normally
aspirated or nitrous applications. Both fuel pressure and oil pressure
are optional sensors and are not needed to run the bike.
There are 5 additional sub harnesses that connect
to the main harness: injector harness, coil harness, input harness,
output harness, and auxiliary (handlebar controls) harness.
- The injector harness connects the main harness
to the injectors. It comes with injector connectors to match your
(customer specified) injectors. Available connectors are Factory Gen 1
Hayabusa, Gen 2 Hayabusa & GSXR1000, Bosch EV1, Bosch EV6. We are
constantly sourcing connectors, so if we don’t list your injectors
contact us.
- The coil harness connects a bosch style igniter
to the factory stick ignition coils. It also has the coil power and
the igniter cylinder head ground.
- The input harness is a flying lead harness that
has a sensor power, sensor ground, digital input #1, digital input #2,
analog input #5, analog input #7, analog input #8. The analog inputs
are generally used for pressure sensors, distance sensors, temperature
sensors, etc. The digital inputs are generally used for on/off events
and speed sensors.
- The output harness is a flying lead harness
that has 12V positive, coil #5, coil #6, output #1, output #2, output
#5, output $8, output #11, output # 12. The outputs are generally used
for nitrous, boost controllers, shift lights, etc.
- The auxiliary (handlebar controls) harness is a
flying lead harness that has a 12V positive, ground, analog input #1,
analog input #2, analog input #3, and output #3. The analog inputs are
generally used for 2 step launch control, shift button, nitrous arm
switch. The output is generally used for the shift light.